Maxtor Digital Multiplex Recorder Network Card User Manual


 
MOTION DETECTION SETUP
1. Press MENU to enter the menu set up, then Down to CAMERA setup.
2. Press ENTERtwice to enter the Motion Detection Setup.
3. Each screen displays the current camera picture overlaid withthe motion targets (as Figure 1).
You can push the button Left or Right , Up or Down to adjust motion detection in ON or OFF.
4. The targets on each motion setup can be turned to ON or OFF individually. To set up targets, using the
front panel buttons:
àPress ENTERto confirm the channel
àPress ENTERto enter motion mode
Up --moves the target cursor up one row at a time.
Down --moves the target cursor down one row at a time.
Left --moves the target cursor left one column at a time.
Right --moves the target cursor right one column at a time.
àPress ENTERto turn the target cursor ON and press ENTERagain to turn the target cursor OFF. (Figure 1-1)
Zoom turns all targets in the current row ON or OFF. (Figure 1-2)
PIP turns all targets on the screen ON or OFF. (Figure 1-3)
5. Press SLOW button to setup the Sensitivity list up to 255 and REC button to setup the Sensitivity list down to 000.
The default value is set on 32.
NOTE : Sensitivity value is related to motion and brightness change. Low value (as 001) means higher sensitivity
on motion and brightness change. High value (as 255) means lower sensitivity on motion and brightness
change. User can choose the suitable sensitivity value in different locations.
NOTE : When motion trigger recording setting is ON, it can automatically switch from stand-by mode to record mode.The
motion detection will change the scanning sequenceand shows on the monitor. There will be an action as
following:
For example : If the motion is detected on Camera #1, its recording & scanning sequence will be more frequent. The
sequence will be as 1st, 2nd, 1st, 3rd, 1st, 16th. And channel 1 will show on the screen. If 2nd cameraand 3rd camera
both motion detection are activated, they will be scanning as 1st, 2nd, 3rd, 2nd, 2nd, 3rd, 3rd, 2nd, 3rd, 4th, 2nd, 3rd and
vice versa. And CH2 & CH3 will show for a period of time which is same as Alarm Duration time.
15
MOTION DETECTION