99-7511S KIT ASSEMBLY
4
DOUBLE DIN/STACKED ISO MOUNT
UNIT(S) PROVISION
Cut and remove the center bar from
the Radio Housing.
(Figure B)
2
Snap the Double DIN brackets to the
inside edge of the Radio Housing.
(Figure C)
3
Slide the Double DIN or stacked ISO
mount unit(s) into the bracket/radio
housing assembly and secure to the
assembly using the screws supplied
with the unit(s). Snap the DDIN Trim
Plate onto the front of the Radio
Housing.
(Figure D)
4
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
A
REAR OF RADIO HOUSING
FILLER TRIM PANEL
B
C
D
Attach the filler trim panel to the back
of the radio housing at the bottom
edge.
(Figure A)
1