Filter
Top Products
50 CenturyStack 8100 Managed Hub
Configuring Ports
The PORT CONFIG menu enables you to configure individual ports or all
ports at one time. You are prompted to enter the password when the
console is locked. The ports must be configured to match the devices at
the other end of the link. Settings such as speed must be identical. All
ports are set to default to AUTO NEGO. When the AUTO NEGO mode is
set, the highest speed supported by both ends is negotiated by the port and
the device at the other end.
In the Port Setting menu, “PORT CONFIG” displays in the message zone
and the currently selected hub is indicated by the “group cursor” under the
port number indicator, as shown below.
Port Configuration
Configuring ALL PORTS
1. With “PORT CONFIG” displayed in the Message Zone,
press Enter to go to the port selection menu. “All PORTS”
displays in the Message Zone.
2. Press <Enter>. The first of the configuration items for all 24
ports is indicated in the Message Zone. Press <Next> to
scroll through all the configuration options. The figure
illustrates the ports that are set to Auto Negotiate enable,
indicated by the columns that have 6 gauge bars, specifically
ports 5, 6, 8, 12, 17, 18, 20, 24. Columns that have only 3
gauge bars indicate the ports that are not set to the configu-
ration displayed in the Message Zone. To change the
configuration, scroll to the desired setting and press and
hold the ENTER key. The new setting displays 6 gauge
bars for all ports.
ID
Master
WWW
SNMP
O-O-B
10
20
40
1
3
5
80
K%123456789101112131415G-A
G-B
G-C
G-D