Filter
Top Products
22
APPENDIX B
Default Settings
Many functions of the scanner can be configured, or enabled/disabled. The
factory programs the scanner to a set of default parameters. These defaults are
marked with an asterisk (*) in the default column on the following pages.
Unmarked parameters show the unavailability for that protocol. To speak with
the host system properly, the scanner must be configured to match the systems
individual requirements. Not all functions support all communication protocols. If
the protocol supports a function, a check mark appears on the chart.
PARAMETER DEFAULT RS-232 RS-422
LIGHT
PEN
INTERFACE FORMAT
RS-232 (RS-422) *
9 9
Light Pen
9
No Comm
Test Mode
Only
CODE TYPES
All UPC/EAN *
9 9 9
Code 39 *
999
Full ASCII Code 39
9 9 9
MOD 43 Check on Code 39
999
Code 93 *
9 9 9
Code 128 *
999
Codabar *
9 9 9
Interleaved 2 of 5 (ITF) *
999
MOD 10 Check on ITF
9 9 9
Do Not Scan EAN-8
999
Do Not Scan EAN-13
9 9 9
Do Not Scan UPC-E
999
Do Not Scan UPC-A
9 9 9
Paraf
999
UCC Supplemental Codes Special firmware required
2 Digits Supps
999
5 Digit Supps
9 9 9
977 (2 Digit Supps)
999
Bookland
9 9 9
Redundancy 2 Digits
999
Redundancy 5 digits
9 9 9
Require Supps
999
100 msec to find Supps *
9 9 9