Metrologic Instruments MS2222 Scanner User Manual


 
29
SCANNER OPERATION
IR ACTIVATION AREA (IR LED OUTPUT)
The StratosS’s default power save mode
is Dual Action Power Save Mode #2 (see page 35). This power save mode
turns the laser OFF after a configured period of non-use then turns the motor OFF after thirty-minute intervals.
Any movement detected by the IR in the activation area, shown below in grey, will cause the scanner to exit the power save
mode. The motor will restart automatically and the laser will turn back on preparing the scanner for bar code recognition,
decoding and transmission.
Figure 30. IR Activation Area Perpendicular to Package Flow (IR LED Output)
Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power save modes.
Specifications are subject to change without notice
.