Filter
Top Products
10
SCALE CONFIGURATION BAR CODES
Single or Dual Cable Scale Configuration Bar Codes
Zero Cursor
The following bar codes can be used to configure a Single or
Dual Cable MS2xx0.
If the MS2xx0 is currently in a Dual Cable configuration, temporarily
disconnect the Scale to Host cable prior to configuring the scale.
The MS2xx0 does not need to be in scale service mode.
The Scale Save Data bar code must be scanned last to save the
changed configuration (see page 2).
Zero Cursor Off
³996092
Turn off the zero cursor that appears on the
display when the scale is in the zero weight
area.
*Zero Cursor On
³996093
Enable the zero cursor to appear on the
display when the weight is within the zero
weight area.
* Factory Default Setting