Filter
Top Products
5
INSTALLATION FOR KEYBOARD WEDGE INTERFACE
1. Turn off the PC/Host.
2. Connect the male 10-pin RJ45 end of
the PowerLink cable to the jack on
the MS7120.
3. Connect the L-shaped plug of the
power supply into the power jack on
the PowerLink cable.
4. Make sure the AC input requirements
of the power supply matches the AC
outlet. Plug the power supply into the
AC outlet. The outlet should be near
the equipment and easily accessible.
5. Disconnect the keyboard from the PC.
Note the type of connector on the
keyboard and keyboard port on the PC.
6. The “Y” end of the PowerLink cable
terminates to female 5-pin DIN and
a male 6-pin mini DIN connector. If
necessary attach the supplied
adapter cable to the appropriate
end of the “Y” cable.
7. Connect one end of the “Y” cable to the Keyboard and other end of
the “Y” to the Keyboard port on the PC.
8. Power up the PC.
Manufacturer’s Recommendation:
Powering Orbit directly from the computer can sometimes cause
interference with the operation of the scanner or the computer. Not all
computers supply the same current through the keyboard port, explaining
why a scanner will work on one computer and not another. Metrologic
recommends using an external power supply. For additional information
contact a Metrologic customer service representative.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the
requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the power
source should meet applicable performance requirements for a limited power source.