Filter
Top Products
51031998EN/AA - Page 19
2. Installation
Connecting the UPS to the AC-input
source
1 - Remove the power cord supplying the
equipment.
Check cord characteristics (> 250 V, 10 A,
see the technical sheet).
2 - Connect the cord to the AC-power socket
␣␣7 on the UPS, then to the AC-power wall
outlet.
Setting the UPS for the installed
battery configuration
(For a 2-hour configuration, skip this step,
this is the default setting for the UPS).
The UPS is set using the “UPS Driver”
personalisation software that comes with the
UPS.
To use the software, use an RS232 cable to
connect a PC to the UPS.
Run the “UPS Driver” software on the
diskette, go to the “battery” menu and select
the type of CLA charger (2, 4 or 8 hours of
backup time).
Once the type of CLA charger has been
selected, click “save” and quit “UPS Driver”.
The installation is now configured.
Connecting the UPS to the
equipment to be protected
1 - Close the battery circuit
breaker.
2 - Connect the protected
equipment to the UPS using
the cords 24 . It is advised to
connect priority loads to the
four outlets ␣ ␣ 4 and any non-
priority loads to the two
programmable outlets 11 .
Tower model
Rack model
2.6 UPS connection and settings
1
2
24
11
4
7
7
4
11
24
ON
OFF