Filter
Top Products
8
Pass: 27 Working
Fail: 0 12
USB(3747M) 219M
Reading: 124M
Wait Too Long
Exit?
Main Menu
There are 6 different Main Menu items for the Copywriter Flash Duplicator: Copy, Compare, Copy
& Compare, Information, Utility, and Setup. For the Setup options, please refer to page 9.
These instructions refer to using 11 USB recorder ports (available only in the USB 11 Flash
Duplicator), but the instructions will not differ when using any of the Copywriter Flash Duplicators.
Any Copywriter Flash Duplicator model will operate using any number of the available recorder
ports.
Copy
The Copy function is used to copy our master card to the blank cards. The steps taken will be
different if you are in Asynchronous or Synchronous duplication.
Asynchronous Duplication
The Copywriter Flash Duplicator will automatically copy Asynchronously if the source content
is less than the duplicator’s memory buffer size, which is displayed during boot-up. The
Analyze Source setting in the Setup menu must be set to ON to enable Asynchronous
Duplication (see page 10).
When the Analyze Source setting is ON and the source is
smaller than the duplicator’s buffer size, the source card
will first be read from the Reader port into the internal
memory. The internal memory contents will then be
compared to the source contents. Once the compare is complete, duplication will begin from
the internal memory to the target cards.
Once the source has been read into the internal memory and successfully compared, the
source card can be removed from the Reader port. You can then use the Reader port as a
Recorder port until a new master card needs to be duplicated.
While in Asynchronous mode, each blank flash card will be written to the moment the
duplicator recognizes the card. As each card finishes, the LED above that card will stop
flashing and can be removed and replaced. Once the new card is recognized, duplication to
that card will automatically begin.
The display will show you how many cards have been
successfully duplicated, how many have failed, and how
many are currently being duplicated.
Asyn Hold Time Setting
Since the Reader port will be usable as a recorder port once the source has been read and
confirmed in the duplicator’s internal memory, there is the risk that a new source card will be
placed in the Reader port while an Asynchronous duplication is in progress, which the
duplicator will then overwrite with the stored data.
The Asyn Hold Time setting will help prevent this from occurring (see page 10). This setting
allows you to specify the amount of time the duplicator will wait with no detected target cards
before exiting an Asynchronous duplication job.
Please note that all ports must be empty, not simply finished duplicating before this setting is
effective. Leaving the source card in the Reader port will also keep the duplicator in
Asynchronous duplication mode.
When there are no target cards detected, you will be
asked if you want to exit the Copy mode for the current
saved source data. Press the OK button to return to the
Main Menu, or ESC to continue with the same saved
source data .