Filter
Top Products
DTIM
Determines the interval the Access Point will send its
broadcast traffic. The range is from 1 to 255 and the default
value is 3 beacons.
Wireless Mode
802.11b – It only allows 802.11b wireless network client to
connect to this router (maximum transfer rate 11Mbps).
802.11g – It only allows 802.11g wireless network client to
connect to this router (maximum transfer rate 54Mbps).
802.11b+g – It only allows 802.11b and 802.11g wireless
network client to connect to this router (maximum transfer rate
11Mbps for 802.11b clients, and maximum 54Mbps for
802.11g clients).
802.11n – It only allows 802.11n wireless network client to
connect to this router (maximum transfer rate 300Mbps).
802.11g+n – It allows 802.11g, and 802.11n wireless network
client to connect to this router (maximum transfer rate
54Mbps for 802.11g clients, and maximum 300Mbps for
802.11n clients).
802.11b+g+n – It allows 802.11b, 802.11g, and 802.11n
wireless network client to connect to this router (maximum
transfer rate 11Mbps for 802.11b clients, maximum 54Mbps
for 802.11g clients, and maximum 300Mbps for 802.11n
clients).
NOTE: For 802.11b and 802.11g mode, the signals can be
transmitted only by antenna 1 (The antenna in the right side
of the rear panel).
For 802.11n mode, the router is operating in a 2T3R Spatial
Multiplexing MIMO configuration. 2 antennas are for signal
transmitting and 3 antennas are for signal receiving.
11n Settings
Parameter Description
Channel Bandwidth
Set channel width of wireless radio. Do not modify default
value if you don’t know what it is, default setting is ‘20/40
MHz’.
Extension Channel
Select the extension channel to above or below the control
channel while 40MHz channel bandwidth is selected. Do not
modify the default value if you don’t know what it is.
Guard Interval
It is one of several draft-n features designed to improve
efficiency. Select 400nsec to provide a shorter delay between
transmission frames in 11n network. The throughput in
400nec guard interval is better than 800nsec guard interval.
MCS
Select MCS 0-15 to configure the data rate of 11n network.
When MCS 15 is selected, the data rate is up to 300Mbps. It
is recommended to set “Auto” and the router will negotiate
with wireless clients to operate in a proper data rate.
SSID Index
This router can support multiple SSIDs. By default, this
function is disabled.
27