Filter
Top Products
130
5-4-8-1. System Configuration
To enable STP mode select the box next to STP State and click so that a
check mark
√
appears. This indicates that STP is enabled on the device.
After enabling STP, configure the system level functions for the device.
The second table displays the current active Root Bridge. The switch will
take on the attributes of the active Root Bridge regardless what has been
configured above.
5-4-8-2. Per Port Configuration
You can configure path cost and priority of each port. This information is
utilized in determining which port is the primary in the root bridge path.
1. Select the port in Port column.
2. Assign the Path Cost. The value range is from 1 to 65535.
3. Assign the port priority value. The value range is from 0 to 255. The lowest
value has higher priority.
4. Click the
Apply
button.
Information about the current spanning tree status is displayed in this table.