Filter
Top Products
6
3. Installation
Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby.
The surface should be clean, smooth, level, and sturdy.
Make sure there is enough clearance around the switch to allow
attachment of cables, power cord and air circulation.
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the switch is grease
and dust free.
B. Remove adhesive backing from the rubber feet.
Figure 3-1. Attaching rubber feet to each corner on the bottom of the
Switch
C. Apply the rubber feet to each corner on the bottom of the switch.
These footpads can prevent the switch from shock/vibration.
Rack-mounted Installation
The MIL-S8000G includes a rack-mounted kit that allows it to be mounted
in an EIA standard size, 19-inch Rack.
Perform the following steps to rack mount the switch:
A. Position one bracket to align with the holes on one side of the switch
and secure it with the smaller bracket screws. Then attach the
remaining bracket to the other side of the switch.