Filter
Top Products
UNINET IMAGING INC. • MINOLTA
®
MAGICOLOR 5430 CARTRIDGE REMANUFACTURING INSTRUCTIONS
9. Release the compression spring on the opposite side of the
drum unit (drive gear side).
Note: The compression springs are different, the longer spring is
connected to the gear train side of the drum and the small spring
is connected to the drive gear side.
10. Locate the developer roller drive gear just below the OPC.
Using a phillips screwdriver, release the screw that holds it in
place. Note: this is a metric screw and will not fit anywhere else.
11. Developer roller drive gear removed. 12. Now, return to the gear train side and locate the pin that hold
the drum unit and developer unit together. Pull the pin out using
a pair of pliers.
© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.
www.uninetimaging.com/technical.asp
11124 Washington Blvd., Culver City, California USA 90232 • Ph +1 310 280 9620 • Fx +1 310 280 0533 • techsupport2@uninetimaging.com