Filter
Top Products
EN - 16
Menu operation (continued)
INSTALLATION
opt.
ON
BACK COLOR
AUTO POWER
ON
AUTO POWER
OFF
SPLASH
SCREEN
LAMP MODE
ON
BLUE
OFF
OFF
STANDARD
OFF
IMAGE
REVERSE
XGA60
CONTRAST
IMAGE
0
BRIGHTNESS 0
STANDARD
0
COLOR
AUTO
0
XGA60
CineRichColor AUTO
OFF
TINT
0SHARPNESS
COLOR TEMP.
GAMMA MODE
sRGB
opt.
1 IMAGE
CONTRAST ............................Use to adjust the image contrast. The contrast
becomes higher as the value increases.
BRIGHTNESS .........................Use to adjust the image brightness. The image
becomes brighter as the value increases.
CineRichColor ........................Use to adjust the white level of the projected
image. Select AUTO for normal use.
sRGB ......................................Choose ON for projection emphasizing on the
color reproducibility.
• When sRGB is ON, CineRichColor, COLOR
TEMP., COLOR, TINT and GAMMA MODE
can't be adjusted.
COLOR TEMP. ........................Use to adjust the color temperature. See page 18.
COLOR ...................................Use to adjust the color intensity of the image.
TINT ........................................Use to adjust the color balance of the image. The
color balance shifts to green as the value increases and shifts to purple as the value
decreases. (Available only when VIDEO or S-VIDEO is chosen as the source.)
• When the TV50 (PAL, SECAM) signal is input, TINT can't be adjusted.
SHARPNESS ..........................Use to adjust the image sharpness. The image becomes sharp as the value increases.
(Not available with certain signals.)
GAMMA MODE ......................When AUTO is selected, the appropriate gamma mode is automatically selected
depending on the input signal. For normal use, select AUTO. Select DYNAMIC for
computer sources. Select STANDARD for sport scenes and video sources. Select
THEATER for fi lm sources.
2 INSTALLATION
AUTO POWER ON .................When ON is chosen, the lamp is automatically lit
when the power cord is plugged in the wall outlet.
Choose ON when using the projector mounted on
the ceiling.
• The projector is in the stand-by mode when the
lamp is off. Use the remote control to turn on
the lamp.
AUTO POWER OFF ................Use to set the time elapsed before the projector
enters the stand-by mode when there is no signal
input from the source.
SPLASH SCREEN ..................Choose ON to display the splash screen when the
power is turned on.
BACK COLOR ........................Use to select the background from among BLUE and BLACK, which will be displayed
when there is no signal input from the source.
LAMP MODE ..........................Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness
is kept low and the projector operating noise is reduced, resulting in a longer lamp
replacement interval.
• When the lamp mode is switched, the projected image may fl icker. This is not a
product malfunction.
• Do not change the setting of LAMP MODE frequently.
For EX100U/EX10U
• When LAMP MODE has been set to LOW, the lamp mode changes from STAN-
DARD to LOW about one minute after turn-on.
For ES100U
• You can’t change the lamp mode for one minute after turning on the projector.
IMAGE REVERSE ...................Use to reverse the projected image. Select MIRROR for rear projection with the
tabletop-mounted projector. Select MIRROR INVERT for front projection with the
ceiling-mounted projector.