Filter
Top Products
EN-14
ProjectorView (continued)
VIRTUAL REMOTE controller
Put a checkmark in the box of the Virtual remote enabled on the ProjectorView main screen, and click the VIRTUAL
REMOTE button. The following Virtual Remote window appears.
For the functional descriptions of each button, see the user manual of the projector.
E-mail notifi cation function
In case of an error or abnormality in the projector, e-mail notification is automatically sent to the designated
address to notify of the error or abnormality.
To use this function, perform the following steps.
1 Enable the LAN control function. (See page 10.)
2 Set the SMTP IP address, E-mail address, E-mail host, and E-mail from.
Once the above-mentioned items are set, the e-mail notifi cation function remains enabled even when the browser
(ProjectorView screen) is closed.
Example of notifi cation: Alert on lamp life end
ProjectorView Alert:
The lamp has reached its maximum usage. Replace the lamp and reset lamp counter. See user guide for complete
instructions.
Projector name : abc
Projector model : FL7000U
Projector location : 10Factory-5F
Serial number : 12345
Operating hours : 2146 hours and 43 minutes
Lamp hours : 4000 hours and 0 minute
Installation date: 2007/01/01
Last lamp replacement date: 2007/01/01
Last maintenance date: 2007/01/01
(Note)
• In case of a command error, e-mail notifi cation isn’t sent.
• When the LAN control is enabled, serial RS-232C commands may not be transmitted.
• You can’t control the LAN/serial RS-232C commands for about 10 seconds after turning on the main power of the
projector.
• When commands for LAN control and for RS-232C control are issued at the same time, the LAN control command
overrides the RS-232C control command.
• While a test pattern is displayed or a password is entered, you can’t change the lamp mode and enable and disable
the MUTE function.
• Response may be delayed depending on the operating state of the projector.
• The DHCP mode may not operate with certain devices (routers etc.).
• When you turn on the projector by pressing the ON/OFF button on the ProjectorView main screen, other commands
are not accepted for about 1 minute.
• E-mail notifi cation is issued twice: at the time of occurrence of an alert/error and 2 hours after the occurrence.
To use the e-mail notifi cation function, confi gure the initial settings in advance as described on the next page.