Mitsubishi Electronics FL7000U Projector User Manual


 
EN-9
1
Enter “0” and press the Enter key.
2
Input the old (current) password and press the Enter
key. (Default password is admin.)
If you input a wrong password, an error message
appears and the setting menu is displayed again.
In this case, set the password again.
If you forget your password, select “7 factory
defaults,” input the password “projectorcontroller,”
and then select “9 save and exit” to perform
initialization.
3
Input a new password (example: “proj2000”) and
press the Enter key.
(Note)
Use single-byte alphanumeric characters only.
4
Input the new password (example: “proj2000”) again
and press the Enter key.
If you input a wrong password, an error message
appears and the setting menu is displayed again.
In this case, set the password again.
Setting the password (Password Setup)
Preparation/SetUp (continued)