Mitsubishi Electronics HD1000 Projector User Manual


 
EN-21
ENGLISH
POWER STATUS
C. Projecting images
Preparation:
Remove the lens cap.
Turn on the power of the connected computer.
1. Confi rm the POWER indicator lights-up red.
If the projector was turned off before the lamp had cooled down suffi ciently, the fan may start rotating and the
POWER button may not work after the power cord is plugged. (The STATUS indicator blinks green.) After the
fan stops rotating, press the power button to turn back on the POWER indicator.
2. Press the POWER button on the projector or ON ( I ) button on the remote control.
It may take about one minute for the lamp to light up.
The lamp fails to light up on rare occasions. In such a case, wait for a few minutes and then try again.
Do not cover the lens with the lens cap while the lamp is on. Do not strip off the aluminium sheet inside the
lens cap.
After the POWER button is pressed, the image may fl icker before the lamp becomes stable. This is not a prod-
uct malfunction.
The STANDARD lamp mode is activated by default whenever the projector is turned on. When the LOW LAMP
MODE has been chosen, the default STANDARD lamp mode is switched to the LOW lamp mode in 1 minute.
The projector starts warming up when the POWER button is pressed. During the warm-up process, images may
appear dark and no commands are accepted.
By blinking red, the STATUS indicator indicates that the lamp should be replaced soon. Replace the lamp when
the STATUS indicator blinks red. (See pages 33 and 36.)
3. Select an input source.
Press the COMPUTER button on the projector or the COMPUTER or HDMI button on the remote control that is
corresponding to the terminal in use.
The input source is switched between COMPUTER and HDMI every time you press the COMPUTER button on
the projector.
Though it may take some time before an image is displayed on the screen depending on the type of the input
signal, such symptom is not a malfunction.
Images may not be projected in the correct position, depending on the type of the input signal. In such a case,
press the AUTO POSITION button. (See page 22.)
The projector automatically selects the appropriate signal format. The selected signal format is displayed on the
screen.
• The
COMPUTER and HDMI buttons don’t function while the menu is being displayed.
When COMPUTER is chosen as the source, images supplied from the computer may fl icker. Press the or
button on the remote control to reduce fl icker, if it occurs.
4. Adjust the position of the projector to keep an appropriate projection distance with which images are projected in
their specifi ed sizes.
5. Adjust the position of the projector so that the projector and the screen are perpendicular to each other. (See page
10.)
When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle. (See page 10.)
6. Adjust the size of the projected image by turning the ZOOM ring.
7. Adjust the focus by turning the FOCUS ring.
Repeat steps 4 to 7, if necessary.
POWER button
COMPUTER button
FOCUS ring
COMPUTER button
HDMI button
ZOOM ring
ON ( I ) button