Filter
Top Products
15
ENGLISH
To operate projector power ON
Numbers 1 - 9 correspond to the instruction numbers below.
Important:
• A darkened image may be seen right after pressing
the POWER button due to warming up of this pro-
jector. While warming up, no other commands can
be accepted.
• When the lamp indicator is blinking red, the ser-
vice life of the lamp is about to end. Replace the
lamp. See pages 32 and 36.
• The picture might not be of optimum performance
in extreme hot or cold conditions. (The projector is
not malfunctioning.)
4. Select the desired external input source by using
the RGB or VIDEO button.
• The projector automatically selects the appropriate
signal format. The selected signal format is displayed
on the SIGNAL menu.
• When selecting the RGB input, the image may
flicker. Press the $ or % button to adjust the im-
age.
• Press the PC CARD button to see the PC CARD im-
ages. (You cannot select it when CARD indicator is
not lighting up.)
1. Turn on the equipment connected to the projector.
2. Put the projector into standby mode by pressing the
main power switch. The POWER indicator lights up
red.
3. Turn the projector on by pressing the POWER but-
ton.
The light source lamp starts warming up, eventu-
ally turn on. In cases where light source lamp does
not come on, wait for one minute before switching
power on again.
• If the main power switch to the unit is turned
off within two minutes of turning off the light
source lamp, power will not be applied to the
lamp for one minute the next time the main
unit power switch is turned on. When this
happens, the indicator lamp will blink for one
minute.
92
LINE-OUTRGB-OUT RGB-IN
S-VIDEO VIDEO
INPUT
L-AUDIO-R
LINE-IN
RS-232C
(MONO)
78
3
4
5
6
RGBLAMP
TEMP
CARD
SOURCE
MENU
ENTER
VIDEO
PC CARD
VOL
condition
indicator
LAMP
POWER
stand-by
-
red
when light source lamp is on green green
when light source lamp does not light up
red
-