Filter
Top Products
E-16
Connecting Personal Computers and Video Equipment
Personal Computers with a Mini D-Sub 15-Pin Connector
• When making connections with the DVI connector of the projector, please make the connection via the supplied DVI/mini D-
Sub 15-pin conversion cable.
The projector has been set to “Auto” at the factory; however, if it does not project, please change the input setting to “RGB”
using the menu sequence of [Setup] → [Input Format] → [PC].
See “Input Format” on Page E-50.
MONITOR OUT
Personal computer
DVI/mini D-Sub 15-pin conversion cable (Supplied item)
Note:
* Before making connections, check the power of the projector and the equipment to be connected is switched off.
* When projection will be with a notebook computer connected, knowledge will be required for the cable connection and notebook computer
startup procedure as well as the operation that follows startup. Please consult the instruction manual of your notebook computer or the on-
line help.
Note:
* When the input format has been switched, you may be required to reconnect the input signal.
* If the position is off or there are dark vertical bands on the picture, press the AUTO button with the screen as bright as possible (make the
screen as bright as possible by for example displaying the trash window over the entire screen). If the problem persists after pressing the
AUTO button several times, set manually at the “Picture Adjustment” menu.