Mitsubishi Electronics WL639U Projector User Manual


 
EN-17
1
2
4
3
1
3
4
2
Connecting to a video player, etc.
1. Connect one end (yellow) of the supplied audio/video cable
to the VIDEO IN terminal of the projector.
2. Connect one end (white and red) of the supplied audio/
video cable to the audio input terminals (L/MONO, R) of the
projector.
3. Connect the other end (yellow) of the audio/video cable to
the video output terminal of the video equipment.
4. Connect the other end (white and red) of the audio/video
cable to the audio output terminals (L, R) of the video
equipment.
When connecting a monophonic video device, use the white (L) terminal to connect the audio cable. (The same
audio signal is output from the channels L and R of the AUDIO OUT terminal.)
Also read the instruction manual of the equipment to be connected.
Contact your dealer for details of connection.
When a TV tuner or VCR is connected:
When you use this projector with a TV tuner or VCR connected, no image may appear or a message of NO SIGNAL
may appear on the screen when you change the channel via any channel that is not being received. In such a case,
set the channels of the TV tuner or VCR again. To avoid such symptom, use the TV tuner or VCR with its channel skip
function (that is a function not to display channels that are not being received) enabled.
When the video equipment is equipped with the S-video
output terminal, make the connection as follows.
1. Connect one end of a commercially available S-video cable
to the S-VIDEO IN terminal of the projector.
2. Connect the other end of the S-video cable to the S-video
output terminal of the video equipment.
3. Connect one end (white and red) of the supplied audio/
video cable to the audio input terminals (L/MONO, R) of the
projector.
4. Connect the other end (white and red) of the supplied
audio/video cable to the audio output terminals (L, R) of the
video equipment.
To VIDEO
IN terminals
To video
output
terminal
Video player, or the like
To S-VIDEO
IN terminal
S-video cable (option)
To S-video
output
terminal
Video player, or the like
Audio/video
cable
Viewing video images
A. Connecting the projector to video equipment
Preparation:
Make sure that the power of the projector and that of the video equipment are turned off.
To audio input
terminals
To audio
output
terminals
To audio input
terminals
Audio/video
cable
To audio
output
terminals
AUDIO OUT
Audio cable (option)
To audio
input
terminals
For audio connection:
1. Connect one end of an audio cable to the AUDIO OUT
terminal of the projector.
2. Connect the other end (white and red) of the audio cable to
the audio input terminals (L, R) of the audio equipment.
When the audio cable is connected to the AUDIO OUT ter-
minal, the speaker output is muted.