Mitsubishi Electronics XD1000 Projector User Manual


 
EN-13
ENGLISH
2
1
AUDIO OUT
AUDIO IN
2
1
2
1
Viewing computer images
A. Connecting the projector to a computer
Preparation:
Make sure that the power of the projector and that of the computer are turned off.
When connecting the projector to a desktop computer, disconnect the RGB cable that is connected to the monitor.
For analog connection:
(For using the COMPUTER/COMPONENT VIDEO IN-1
terminal.)
1. Connect one end of the supplied RGB cable to the
COMPUTER IN/COMPONENT VIDEO IN-1 terminal of the
projector.
2. Connect the other end of the RGB cable to the monitor
port of the computer.
When viewing images supplied from an analog-connected
computer, press the COMPUTER button on the remote
control.
For analog connection:
(For using the COMPUTER/COMPONENT VIDEO IN-2
terminal.)
1. Connect one end of a commercially BNC cable to the
COMPUTER IN/COMPONENT VIDEO IN-2 terminal of the
projector.
2. Connect the other end of the BNC cable to the 5 BNC
terminals of the monitor port of the computer.
For digital connection:
1. Connect one end of a commercially available DVI cable to
the DVI-D (HDCP) terminal of the projector.
2. Connect the other end of the DVI cable to the DVI terminal
of the computer.
When viewing images supplied from a digital-connected
computer, press the DVI-D(HDCP) button on the remote
control.
Turn on the main power switch of the projector before
starting the computer.
For audio connection:
1. Connect one end of a commercially available PC audio
cable to the AUDIO IN-1/2 terminal of the projector.
2. Connect the other end of the PC audio cable to the audio
output terminal of the computer.
This projector uses stereo pin jack for its audio input. Check
the type of the audio output terminal of the connected
computer and prepare a proper cable for connection. Some
computers don't have the audio output terminal.
Speaker output is mono.
COMPUTER IN/COMPONENT
VIDEO IN-1
DVI-D (HDCP)
to monitor port
RGB cable
DVI cable
to DVI
Computer
PC audio cable (option)
to audio output
terminal
2
1
42
4
); $2
$
**8 8
8 **8 $2
$
); 42
4
COMPUTER IN/COMPONENT
VIDEO IN-2
Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending
on the type of the computer to be connected.
Use of a long cable may decrease the quality of projected images.
Images may not be projected correctly, depending on the type of the connected computer.
When DVI-D signal is input, some signal setting menus are unavailable.
Also read the instruction manual of the equipment to be connected.
Contact your dealer for details of connection.
to monitor port
(5 BNC)