Mitsubishi Electronics XD110 Projector User Manual


 
EN-16
Menu operation (continued)
1IMAGE
CONTRAST.................................Use to adjust the image contrast. The contrast
becomes higher as the value increases.
BRIGHTNESS .............................Use to adjust the image brightness. The image
becomes brighter as the value increases.
WHITE ENHANCE ......................Use to adjust the white level of the projected image.
Select AUTO for normal use.
COLOR TEMP.............................Use to adjust the color temperature. See page 18.
COLOR........................................Use to adjust the color intensity of the image.
TINT.............................................Use to adjust the color balance of the image. The
color balance shifts to green as the value increases
and shifts to purple as the value decreases. (Avail-
able only when VIDEO or S-VIDEO is chosen as the
source.)
When the TV50 (PAL, SECAM) signal is input, TINT can’t be adjusted.
SHARPNESS ..............................Use to adjust the image sharpness. The image becomes sharp as the value increases. (Not
available with certain signals.)
GAMMA MODE ..........................When AUTO is selected, the appropriate gamma mode is automatically selected depending on
the input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select
STANDARD for sport scenes and video sources. Select THEATER for film sources.
2 INSTALLATION
AUTO POWER ON......................When ON is chosen, the lamp is automatically lit
when the power cord is plugged in the wall outlet.
Choose ON when using the projector mounted on the
ceiling.
The projector is in the stand-by mode when the
lamp is off. Use the remote control to turn on the
lamp.
AUTO POWER OFF ....................Use to set the time elapsed before the projector
enters the stand-by mode when there is no signal
input from the source.
SPLASH SCREEN ......................Choose ON to display the splash screen when the
power is turned on.
BACK COLOR.............................Use to select the background from among BLUE and BLACK, which will be displayed when there
is no signal input from the source.
LAMP MODE...............................Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept low
and the projector operating noise is reduced, resulting in a longer lamp replacement interval.
When the lamp mode is switched, the projected image may flicker. This is not a product mal-
function.
Do not change the setting of LAMP MODE frequently.
When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW
about one minute after turn-on.
IMAGE REVERSE.......................Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-
mounted projector. Select MIRROR INVERT for front projection with the ceiling-mounted projec-
tor.
CONTRAST
IMAGE
0
BRIGHTNESS 0
STANDARD
0
COLOR
AUTO
0
XGA60
WHITE ENHANCE AUTO
TINT
0SHARPNESS
COLOR TEMP.
GAMMA MODE
opt.
INSTALLATION
opt.
ON
BACK COLOR
AUTO POWER
ON
AUTO POWER
OFF
SPLASH
SCREEN
LAMP MODE
ON
BLUE
OFF
OFF
STANDARD
OFF
IMAGE
REVERSE
XGA60