Mitsubishi Electronics XL2U Projector User Manual


 
EN 12
Adjustment foot
screen
Preparing the projector for operation
Getting ready for projection
1. Connect the power cord provided to the projector.
2. Connect the power cord to the wall power outlet.
3. Remove the lens cap.
Warning:
Do not look directly into the lens when projector is
ON.
The lens cap is for protecting the lens. If you leave
the power on with the cap on, the cap may be warped.
Please remove the lens cap when you turn the power
on.
This projector is equipped with the power cords for
both U.S. and Europe. Use the appropriate power
cord for your country.
A three-pin grounding type power plug is used with
the projector. Do not remove the grounding pin on
the power plug. If you are unable to insert the plug
into the outlet, contact your electrician to replace
your A/C outlet.
The supplied power cord for U.S. is used for 120V
only. Never connect to any outlet or power supply
having a different voltage or frequency. If you
connect to the power supply having a different
voltage, please use the appropriate power cord.
Use 100-240V AC 50/60Hz correct voltage other-
wise it may lead to fire or electric shock.
Do not place any objects on the power cord, and keep
the projector away from heat sources to avoid break-
ing the power cord. A broken power cord can cause
fire or electric shock.
Do not revise or alter the power cord otherwise it
may cause fire or electric shock.
Contact your dealer if the cord is broken.
Caution:
Plug in firmly and unplug by holding the plug, not
by pulling the cable out.
Do not plug in or out with wet hands. It may cause
an electric shock.
Adjusting the angle of projection
For the best result, project onto a flat screen with a 90
degree angle to the floor. If necessary, tilt the projector
by adjusting two foot adjustments on the bottom of the
projector.
1. Lift the projector to the appropriate angle.
2. Press the buttons by the projectors adjustable front
feet, this will allow the feet to slide out to the ap-
proximate position.
3. Release the foot adjustment buttons to lock the feet
in that position.
4. Rotate the projector feet for fine adjustment.
After using the projector
5. Return the adjustable feet into the projector.
Install the screen on a flat wall at 90 degrees to the
floor.
Position the projector so that it projects an image
filling the screen as illustrated on page 9.
Keep an appropriate distance from the projector
to the screen according to the screen size chart on
page 9.
The image becomes trapezoid shape when the
screen or project is not level. Use KEYSTONE
button and + or - buttons on the remote control to
adjust, however, the circumference of the image
may not be focused.
Important:
Slanting the projector more than ±10˚(right and left)
or ±15˚ (front and rear) may cause trouble or explo-
sion of the lamp. You can tilt the projector up to 7
degrees using the adjustment feet only.
The image may not be projected in a shape of a
regular rectangle or with its aspect ratio of 4:3,
depending on the installation conditions of the
projector and the screen.
When the keystone adjustment is carried out, the
adjustment value is indicated. Note that this
value doesnt mean a projection angle.
The allowable range of the adjustment value in
the keystone adjustment will vary depending on
the installation conditions.
Adjustment foot
Front height
adjuster button