Filter
Top Products
CP-118U User’s Manual Software Installation
3-49
Execute the following commands from the Linux prompt:
1. #mount /dev/cdrom /mnt/cdrom
#cd /
#mkdir moxa
2. #cd moxa
#cp /mnt/cdrom/<driver directory>/mxser.tgz .
3. #tar xvfz mxser.tgz
4. #cd mxser
#make clean; make install
5. #cd /moxa/mxser/driver
#./msmkod
6. #modprobe mxser
(If you install ISA Boards, use the command # insmod mxser ioaddr=0x???, 0x???, 0x???,
0x??? <- 1st ISA, 2nd ISA, 3rd ISA, 4th ISA)
Using /lib/modules/2.4.20-8/kernel/drivers/char/mxser.o
Warning: loading /lib/modules/2.4.20-8/kernel/drivers/char/mxser.o will taint the kernel: no
license
See http://www.tux.org/lkml/#export-tainted for information about tainted modules
MOXA Smartio/Industio family driver version 1.7
Tty devices major number = 30, callout devices major number = 35
Found MOXA CP-118U series board (BusNo=2,DevNo=13)
Module mxser loaded, with warnings
7. Use the Moxa diagnostic utility to verify the driver status:
#cd /moxa/mxser/utility/diag
#./msdiag
= MOXA Smartio/Industio Family Multiport Board Status Utility(1.1)=
Tty Device Major Number= 30.
Callout device Major Number= 35.
Board 1 : CP-118U series (BusNo=2, DevNo=13)
Port 1: 0xac00, max. baud rate = 230400 bps.
Port 2: 0xac08, max. baud rate = 230400 bps.
Port 3: 0xac10, max. baud rate = 230400 bps.
Port 4: 0xac18, max. baud rate = 230400 bps.
Port 5: 0xac20, max. baud rate = 230400 bps.
Port 6: 0xac28, max. baud rate = 230400 bps.
Port 7: 0xac30, max. baud rate = 230400 bps.
Port 8: 0xac38, max. baud rate = 230400 bps.
8. Use the Moxa terminal utility to test the tty ports:
#cd /moxa/mxser/utility/term
#./msterm