Moxa Technologies EDS-305 Switch User Manual


 
6
Wall Mounting (OPTIONAL)
For some applications, you will find it convenient to mount MOXA EtherDevice Switch on the
wall, as illustrated below.
STEP 1:
Remove the aluminum DIN-Rail attachment plate from MOXA EtherDevice Switch’s rear panel,
and then attach the wall mount plates, as shown in the diagram below.
top
plate
bottom
plate
STEP 2:
Mounting MOXA EtherDevice Switch on the wall requires 4 screws. Use the
Switch, with wall mount plates attached, as a guide to mark the correct
locations of the 4 screws. The heads of the screws should be less than 6.0 mm
in diameter, and the shafts should be less than 3.5 mm in diameter, as shown
in the figure at the right.
NOTE
Before tightening screws into the wall, make sure the screw head
and shank size are suitable by inserting the screw into one of the
keyhole-shaped apertures of the Wall Mounting Plates.
Do not screw the screws in all the way—leave about 2 mm to allow room for
sliding the wall mount panel between the wall and the screws.
6.0 mm
3.5 mm
STEP 3: Once the screws are fixed in the wall, insert the four screw heads through the large parts
of the keyhole-shaped apertures, and then slide MOXA EtherDevice Switch downwards,
as indicated below. Tighten the four screws for added stability.