Filter
Top Products
NPort IA5150/5250 Series User’s Manual Web Console Configuration
5-34
Password changed
The user has changed NPort IA5150/5250’s password. When the password changes, NPort
IA5150/5250 will send an e-mail with the password changed notice before NPort IA5150/5250
reboots. If the NPort IA5150/5250 is unable to send an e-mail message to the mail server within 15
seconds, NPort IA5150/5250 will reboot anyway, and abort the e-mail auto warning.
Power failure
We provide two DC power inputs for redundancy. NPort IA supports different approaches to warn
engineers automatically, such as by email or relay output (which closes the circuit). Users can
connect to Monitor Æ Relay Output from the web console to check what event causes the warning.
The relay output will be canceled after the power recovers, or by selecting “acknowledge event”
using the web console or Telnet.
When the Relay Output is sending a warning, the Ready LED will flash red until the warning
event ceases.
Ethernet1 link down
NPort IA can provide system maintainers with real-time alarm messages. Even when control
engineers are out of the control room for an extended period of time, they can still be informed of
the status of devices almost instantaneously when exceptions occur. NPort IA supports different
methods for warning engineers automatically, such as by email, SNMP trap, and relay output
(which closes the circuit). Users can connect to Monitor Æ Relay Output from the web console to
check which event is causing the warning. The relay output will be canceled if Ethernet link 1 is
restored, or by selecting “acknowledge event” from the web console or Telnet.
When the Relay Output is issuing a warning, the Ready LED will flash in red until the warning
event ceases.
Ethernet2 link down
NPort IA can provide system maintainers with real-time alarm messages. Even when control
engineers are out of the control room for an extended period of time, they can still be informed of
the status of devices almost instantaneously when exceptions occur. NPort IA supports different
methods for warning engineers automatically, such as by email, SNMP trap, and relay output
(which closes the circuit). Users can connect to Monitor Æ Relay Output from the web console to
check which event is causing the warning. The relay output will be canceled if Ethernet link 2 is
restored, or by selecting “acknowledge event” from the web console or Telnet.
When the Relay Output is issuing a warning, the Ready LED will flash in red until the warning
event ceases.