Filter
Top Products
12
MultiModemISDN User Guide
MTA128ST-USB
Introduction
This chapter details the contents of the MTA128ST-USB shipping container, describes
each cable connection, and describes the LED indicators.
Unpacking Your MTA128ST-USB
The shipping box contains the MTA128ST-USB, an external power supply, one RJ-45
line cord, one RJ-11 phone cord, one USB cable, your Quick Start Guide, and two
diskettes (i.e., the MTA128ST-USB User Guide and the MTA128ST-USB Driver
Software). Inspect the contents for signs of any shipping damage. If damage is
observed, do not power up the unit; contact Multi-Tech’s Technical Support for advice
(refer to Chapter 6). If no damage is observed, place the MTA128ST-USB in its final
location and refer to “Connecting the MTA128ST-USB to Your System” in the next
section.
MADE IN U.S.A
MADE IN U.S.A
Quick Start Guide
Four USB V.90 Modems
T
D
R
D
L
S
B
1
B
2
T
R
O
H
1
2
8
P
1
P
2
U
S
B
I
S
D
N
M
o
d
e
m
w
i
t
h
A
n
a
l
o
g
P
o
r
t
Figure 2-1. Unpacking
Safety Warning Telecom/ISDN-ST
1. Never install telephone wiring during a lighting storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
3. This product is to be used with CE approved/marked computers.
4. Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
5. Use caution when installing or modifying telephone lines.
6. Avoid using a telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electrical shock from lightning.
7. Do not use the telephone to report a gas leak in the vicinity of the leak.
8. To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line
cord.
9. If S/T - interface ISDN network connection cable is used, the ISDN phone cord
should be connected between the ISDN network connection cable and a NT1 device.