Filter
Top Products
14
MultiFRAD 3000-Series User Guide
Introduction
This chapter will guide you through the unpacking and installation of your MultiFRAD. The installation
procedure, which is preceded by important safety instructions, will provide step by step instruction on
cabling and powering-on the MultiFRAD. Chapter 3 will provide instruction on loading and
configuring the MultiFRAD software.
Unpacking your MultiFRAD 3000
Remove all items from the box. Your shipping box should contain the MultiFRAD, a power supply,
various cables, software and manual diskettes, and a MultiFRAD 3000-Series Quick Start Guide.
Please inspect all items before proceeding with the installation. If any of the items appears to be
damaged in any way, do not power up the unit; contact Multi-Tech’s Technical Support personnel for
advice (See Chapter 6). If no damage is observed, configure the MultiFRAD using the information in
this chapter.
3000-Series
Router/Multiport Data/Voice/Fax
Frame Relay Access Device
Voice/Fax Channel 8
Voice/Fax Channel 7
Voice/Fax Channel 6
Voice/Fax Channel 5
Voice/Fax Channel 4 Voice/Fax Channel 3 Voice/Fax Channel 2
Voice/Fax Channel 1
XSG
RSG
XMT
RCV
E&M
FAX
FXS
FXO
XSG
RSG
XMT
RCV
E&M
FAX
FXS
FXO
XSG
RSG
XMT
RCV
E&M
FAX
FXS
FXO
XSG
RSG
XMT
RCV
E&M
FAX
FXS
FXO
XSG
RSG
XMT
RCV
E&M
FAX
FXS
FXO
XSG
RSG
XMT
RCV
E&M
FAX
FXS
FXO
XSG
RSG
XMT
RCV
E&M
FAX
FXS
FXO
XSG
RSG
XMT
RCV
E&M
FAX
FXS
FXO
Composite Link
Ethernet
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
Channel 9 Channel 10
XMT
RCV
XMT
RCV
XMT
RCVXMT
RCV
XMT
RCV
XMT
RCV
XMT
RCV
XMT
RCV
BTG
PWR
LNK
EXT
V35
CTS
CD
XMT
RCV
XMT
RCV
COL
LNK
XMT
RCV
V35
XMT
RCV
V35
Figure 2. Unpacking
Safety Warnings
Caution
Danger of explosion if battery is incorrectly replaced.
A lithium battery on the voice/fax channel board provides backup power for the time keeping
capability. The battery has an estimated life expectancy of ten years.
When the battery starts to weaken, the date and time may be incorrect. If the battery fails, the
board must be sent back to Multi-Tech Sytems for battery replacement.
The E&M, FXS, and Ethernet ports are not designed to be connected to a Public
Telecommunication Network.
Valid Voice/Fax Channel Connections
The following Voice/Fax channel connections can be made at this time:
• FXS to FXS • FXS to FXO
• FXS to E&M • E&M to E&M