Filter
Top Products
20
MultiMobile User Guide
MT5634ZLX/E
9. Click Next > three times to use default NETWORK SERVICES settings.
10. Enter the correct path for NT 4.0 system source files and click Next >.
11. The Multi-Tech Combo Card Setup dialog box is displayed.
Check the settings against the Network settings (See step 2) and if there are no conflicts,
accept the defaults and click Continue.
Note: Make a note of the COM port setting (usually COM port 3) so that when you’re
installing the modem (See Modem Configuration for NT 4.0), the COM port selection matches
the COM port listed in the Multi-Tech Combo Card Setup dialog box.
12. The Microsoft TCP/IP Properties dialog box is displayed.
CAUTION: The IP Address, Subnet Mask, (See example in dialog box above) and Default
Gateway address must be entered by the network administrator. Once the information has
been entered, click Apply and then OK.
13. The Network Settings Change dialog box is displayed.
Remove the driver disk and then click Yes to save the settings to the system and reboot
Windows NT.