Filter
Top Products
Chapter 3 – Using Your Wireless Modem
Multi-Tech Systems, Inc. MultiModem CDMA Wireless Modem User Guide 18
Establishing a Voice Call
• Initiate a voice call
Type ATD1234; (Note: Don’t forget the semicolon “;” at the end. This stands for voice calls)
Responses: OK (Communication established)
CME ERROR : 11 (PIN Code not entered [with +CMEE : 1 mode])
CME ERROR : 3 (Operation not allowed)
• Initiate an emergency call
Type ATD112; (Note: Don’t forget the semicolon “;” at the end. This stands for voice calls)
Responses: OK
• Hang up
Type ATH
Responses: OK
Establishing a Circuit-Switched Data (CSD) Connection
A Circuit-Switched Data Connection makes the wireless modem work like a regular analog modem. You must
have CSD service in order to make a CSD call.
Establish a Connection: Using HyperTerminal or a terminal application, you can establish a CSD
connection by entering the following command: ATD<phone number>
Notes:
• The phone number you are calling is entered between the displayed
brackets. Do not type additional brackets. For example, type only ATD
8585551212. 8285551212 is typed between the brackets.
• This command tells the modem to inform the wireless network that you are
initiating a CSD modem call. If you are dialing to another modem, the
remote modem should answer and a connection between the two modems
will be established. If you include a semi-colon (;) at the end of the dialing
string, the modem will instead initiate a Voice call to the phone number
dialed.
Disconnect: Type: +++
Wait about two seconds to see an OK response.
Then type: ATH
Note: +++ is the escape sequence and ATH is the Hang-up command.
Answering a Circuit-Switched Data (CSD) Connection
A Circuit-Switched Data Connection makes the wireless modem work like a regular analog modem. You must
have CSD service in order to answer a CSD call.
Establish A Connection: Using HyperTerminal or a terminal application, enter the following command:
AT+CICB=0 <cr> This sets the modem to answer in data mode.
Then, call into the modem by dialing the number provided by your carrier.
Answer a Call: When you see the RING responses on the terminal screen, enter ATA <cr> to
answer the call.
Set Auto-Answer: Enter ATS0=x
This sets the modem to auto-answer. The call will be answered after the number
of rings entered. x stand for the number rings.
Then call into the modem by dialing the number provided to you by the carrier.
Disconnect: Type: +++
Wait about two seconds to see an OK response.
Then type: ATH