Filter
Top Products
security device as drawn left with functions described in the table next page. The
function for enabling each track of course comes in effect only when the track is
physically available.
The default status of JP1 for normal ISO reader delivery is: pin pairs 1-
2, 3-4 and 5-6 short while all the rest kept open.
Pin Pair in JP1 Function When Short When Open
1 – 2 Track 1 Enabled Disabled
3 – 4 Track 2 Enabled Disabled
5 – 6 Track 3 Enabled Disabled
7 – 8 MSR Type JIS II ISO
9 – 10 Reserved N.A. N.A.
11 - 12 Leading / Stop Code Disabled Enabled
For ISO MSR in KP100 or KB4000, please find in the CD ROM attached
to the system for the product KP100 or KB4000 under subdirectory drivers and
then Jiva (TP series) or TM4000 etc. according to what the host system is and
then look for KP100 (usually referred to as KBM) for installation of the program
controlling the keypad. Please in the controlling program after installation enter
the configuration of the keypad and then access the configuration for the MSR.
The features controllable in this program are the same as that for SD100 by
jumper setting.
For the special type MSR in SD100, please find the subdirectory MSR
instead of SD100 in the CD ROM attached to the system that SD100 is to be
applied to for installation of a Posiflex MSR Manager for user to determine
some parameters in reader output. Please always make sure that the system
supports the MSR connector before finding the MSR subdirectory in CD ROM.
PROGRAMMABLE KEYPAD
Keytop Replacement
The keypad in KB4000 or KP100 is organized into 2 parts: a 4 by 4
numerical keypad area and a 4 by 6 programmable keypad area. However, this
keypad allows some layout alterations by the system integrator. Besides the
standard single key installed, there are double keys and blank keys for purchase
to provide more convenient interface with the user.
KB4000 Series User’s Manual
3 - 3