Filter
Top Products
TP6000 USER’S MANUAL 3 - 6
CONNECTING CABLES
Connect the required cables to the appropriate connectors. Please make sure
that each connector is connected to the right port with the correct orientation. Some
connectors, such as the LAN connector, the external FDD connector, the power
connector, the cash drawer connector, and the COM4 connector for the conversion
cable have to be inserted until a click is heard. It is recommended that connectors such
as the external VGA connector, the LPT port connector and the COM port connectors,
be screwed into place once seated. If the COM1 port must be used, the COM1
terminator that occupies the COM1 port must be removed. However, when using the
COM1 port, be sure to use devices that provide proper handshaking signals in order to
keep the cash drawer control features. A serial mouse is one example of a device that
does not support handshaking. Adjust the slack of each cable and close the cable
cover. Use the same plastic latch key that is used when removing the cable cover, but
be sure to turn it in the clockwise direction to lock the cover in place. Re-adjust the tilt
angle of the screen for best viewing.
CAUTION: Before inserting or extracting the power plug, be sure to pull the
outer sleeve of the plug away from the machine to release the
internal latch. Failure to do this could damage the power connector.
Such damage is considered to be user error, and will not be covered
by the warranty.
INSTALLING CASH DRAWERS
When there is only one cash drawer installed, connect the standard cable
CCBLA-180 or CCBLA-180-1 that comes with the cash drawer to the RJ11C jack
next to the PS2 KB connector (be careful not to connect this cable to the Modem
connector or the COM4 connector on the left).
When there are two cash drawers being installed, please purchase and use the
optional cash drawer control splitter cable CCBLA-238. The CCBLA-238 has a 6 pin
male connector at one end and two 8 pin male connectors at the other. The 6 pin
connector should be inserted in the connector marked “CR”, found on the cabling
panel of the TP6000 series. Each 8 pin connector should be inserted into the connector