Filter
Top Products
* The unit is designed to be operated with your bare fingers. If you touch the
control panel with your gloved fingers or with something left on the control
panel, it may not work.
* If there are waterdrops or dew condensation on the control panel, or operating
with wet fingers, it may not work properly. In that case, be sure to dry or wipe it
up before use.
6.Change SIGNAL 1 (DVI-I Connector) in the Input Selection menu to
"ADC".
Touch the Enter switch to complete the setting and the menu closes.
7.Switch on the PC's power.
If an image does not appear, refer to the "6. TROUBLESHOOTING" for advice.
Whenever finished, turn off the PC and the monitor.
* When turning on the monitor, the kid of the input signal (Signal1 or 2/Analog or
Digital) is displayed for a few seconds on the right top corner of the screen.
* Adjust brightness of the screen depending on the brightness of your environment.
* Be sure to take adequate rests. A 10-minute rest period each hour is suggested.
* When changing the signal connector except ADC, open the Input Selection menu
again and change the setting to "Standard".
* To <Reset> the settings in the <Others> menu through ScreenManager, the
settings of Input Selection will revert to the default setting.