Filter
Top Products
Selecting the Active Input
The Input Signal Selection button on the control panel can be used to select either
SIGNAL 1 or SIGNAL 2 as the active input at any time. Every time the button is
pressed, the input changes. When switching the signal, the kind of the input signal
(Signal 1 or 2/ Analog or Digital) is displayed for a few seconds on the right top corner
of the screen.
The Priority Input Signal
This function is used to select which PC will have priority to control the monitor when
utilizing two PCs. The monitor constantly checks the input signals and switches
automatically in accordance with the "Input Priority" setting (see table below). Once a
priority is set, whenever a change of signal is detected at the selected input, the
monitor will switch the input to that signal.
In this case of only one signal being present at either input, the monitor automatically
detects and displays that signal.
Priority
Settings
Performance
1
(SIGNAL1)
If signals from both inputs are present, the monitor gives
preference of Signal 1 in the following cases.
● When the power of the monitor is turned ON.
● When the signal input to Signal 1 is changed even if active
input was Signal 2.
2
(SIGNAL2)
If signals from both inputs are present, the monitor gives
preference to Signal 2 in the following cases.
● When the power of the monitor is turned ON.
● When the signal input to Signal 2 is changed even if active
input was Signal 1.