Filter
Top Products
36 6. CONNECTING TWO PCs TO THE MONITOR
Selecting the active input
The Input signal selection button on the front
panel can be used to select either Signal 1 or
Signal 2 as the active input at any time. Every
time the button is pressed, the input changes.
When the switching the signal, the displaying
signal kind (signal 1 or 2/Analog or digital) is
displayed for a few seconds.
The priority input signal
This function is used to select which PC will have priority to control the monitor when
utilizing two PCs. The monitor constantly checks the input signals and switches
automatically in accordance with the “Input Priority” setting (see table below).
Once a priority is set, whenever a change of signal is detected at the selected input, the
monitor will switch the input to that signal.
In the case of only one signal being present at either input, the monitor automatically
detects and displays that signal.
Priority setting Performance
Signal 1 If signals from both inputs are present, the monitor gives preference
to Signal 1 in the following cases.
• When the power of the monitor is turned ON
• When the signal input to Signal 1 is changed even if active input
was Signal 2.
Signal 2 If signals from both inputs are present, the monitor gives preference
to Signal 2 in the following cases.
• When the power of the monitor is turned ON
• When the signal input to Signal 2 is changed even if active input
was Signal 1.
Manual The monitor will not detect signals automatically in this mode.
Select the active input by pressing the input signal selection button
on the monitor’s front panel.
• Regarding the power saving mode
When the Signal 1 or Signal 2 is selected, the power saving mode of the monitor
activates only if both PCs are in power saving mode.
Input Signal
Selection Button
SIGNAL
1-2
AUTO
ENTER