Filter
Top Products
12 2. INSTALLATION
2. Plug the power cord into the power connector at the rear of the
monitor. Then plug the other end of the cord into a power outlet.
WARNING
• The equipment must be connected to a grounded main
outlet.
• Use the enclosed power cord. If using the power cord
other than the enclosed one, use the following cord.
[USA and Canada]
Use a UL LISTED/CSA LABELED or CERTIFIED power cord
set meeting the following specifications:
* Rating: min. 125 V, 10 A
* Length: max.2.0 m
* Type: SVT
* Plug type: NEMA 5-15P, Parallel blade,
Grounding type, 125 V, 10 A
[Europe]
Use a proper European standard approved power cord
meeting the following specifications:
* Rating: min. 250 V, 10 A
* Length: max. 2.0 m
* Type: H05VV-F 3G 1 mm2
Use a plug type approved by the country where you reside.
Failure to do so may cause fire or electric shock.
3. Turn on the monitor first, then the PC.
The monitor’s power indicator will light up (green). The monitor will warm up
briefly, then display an image. Whenever finishing your operation, turn off the PC
and the monitor.
(If an image does not appear, make sure that all connections have been made
properly. Refer to the “TROUBLE SHOOTING”(See page 22) for additional
advice.)
• Generally, for maximum viewing comfort, position the
monitor slightly below eye level. Staring at the monitor for
prolonged periods can cause eye strain. Be sure to take
adequate rests.
(A 10-minute rest period each hour is suggested.)