Filter
Top Products
English
18 2. CABLE CONNECTION
5. Press the power button while pressing the Input Signal Selection
button.
The Input Selection menu is appeared on the screen.
Input Signal Selection
Button
Enter Button
Control Buttons
(Up, Down, Left, Right)
Power Button
Power
Indicator
6. Change SIGNAL 1 (DVI-I Connector) in the Input Selection menu to
“ADC”.
Press Enter button to complete the setting and the menu closes.
7. Switch on the PC's power.
The monitor’s power indicator will light up (blue).
If an image does not appear, refer to the “7. TROUBLESHOOTING” (p.40) for
additional advice.
Whenever finishing your operation, turn off the PC and the monitor.
NOTE
• When changing the signal connector except ADC, open the Input Selection menu
again and change the setting to “Standard”.