Filter
Top Products
2
W415-0583 / A / 01.09.07
PG 2-5 INTRODUCTION
Warranty
Dimensions
General Instructions
General Information
Care of Glass & Plated Parts
5-9 VENTING
Vent lengths
Venting Specifi cations
Air Terminal Locations
10-15 INSTALLATION/FRAMING
Wall & Ceiling Protection
Using Flexible Vent Components
Fireplace Vent Connection
Using Rigid Vent Components
Gas Installation
Restricting Vertical Vents
Framing
Clearance to Combustibles
Mantle Clearances and Enclosures
15 ELECTRICAL CONNECTION
Hard Wiring Connections
Schematic
16 FINISHING
Blower Replacement
Bowl, Mesh & Rock Replacement
17-18 REMOTE AND VALVE ACCESS
Door Removal
Burner Assembly Removal
Battery Replacement
19 NIGHT LIGHT
TM
REPLACEMENT
19-23 OPERATION / MAINTENANCE
Time Out
Fireplace Operation
Hand Held Remote Operation
Dip Switch Number Chart
Operating Instructions
24 ADJUSTMENTS
Pilot Burner Adjustment
Venturi Adjustment
25-26 REPLACEMENTS
Replacement Parts
Flexible Vent Kits
Terminal Kits
Roof Terminal Kits
Accessories
Replacement Parts Diagram
27-28 TROUBLE SHOOTING GUIDE
29 SERVICE HISTORY
30 NOTES
WARNING
• Do not burn wood or other materials in this fi replace.
• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to
avoid burns or clothing ignition. Keep young children and animals away when the fi replace is hot.
• Due to high temperatures, the fi replace should be located out of traffi c and away from furniture and draperies.
• Clothing or other fl ammable material should not be placed on or near the fi replace.
• Any safety screen or guard removed for servicing must be replaced prior to operating the fi replace.
• It is imperative that the control compartments, burners and circulating blower and its passageway in the fi replace
and venting system are kept clean. The fi replace and its venting system should be inspected before use and at least
annually by a qualifi ed service person. More frequent cleaning may be required due to excessive lint from carpeting,
bedding material, etc. The fi replace area must be kept clear and free from combustible materials, gasoline and other
fl ammable vapours and liquids.
• Under no circumstances should this fi replace be modifi ed.
• This fi replace must not be connected to a chimney fl ue pipe serving a separate solid fuel burning appliance.
• Do not use this fi replace if any part has been under water. Immediately call a qualifi ed service technician to inspect the
fi replace and to replace any part of the control system and any gas control which has been under water.
• Do not operate the fi replace with the glass door removed, cracked or broken. Replacement of the glass should be done
by a licensed or qualifi ed service person.
• Do not strike or slam shut the fi replace glass door.
• This fi replace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by
Wolf Steel Ltd.
NOTE: CHANGES, OTHER THAN EDITORIAL, ARE DENOTED BY A VERTICAL LINE IN THE MARGIN.
TABLE of CONTENTS
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE