Filter
Top Products
Hardware Configuration and Installation Chapter 2
STD-GPIB for Windows 2-4 © National Instruments Corp.
Configure the Hardware
Follow the instructions in this section to change the hardware settings of the STD-GPIB
before you install it. The default settings are suitable for most STD systems, but you
need to change the hardware settings in the following situations:
• If you want to use interrupts for the STD-GPIB
• If the default settings conflict with another device in your system
• If you are installing more than one STD-GPIB
The default settings for the switches and jumpers on the STD-GPIB are as follows:
• Base I/O Address (hex): 2C0
• DMA Channel: 5
• Interrupt Line (IRQ): None