Filter
Top Products
Contents
STD-GPIB for Windows viii © National Instruments Corp.
Presence Test of Module..................................................... 4-5
GPIB Cables Connected ..................................................... 4-6
Common Questions ......................................................................................... 4-6
Chapter 5
Using Your NI-488.2 Software
.......................................................................... 5-1
Introduction to the Win16 Interactive Control Utility..................................... 5-1
General Programming Considerations............................................................. 5-1
Appendix A
Hardware Specifications
.................................................................................... A-1
Appendix B
Interrupt Routing
................................................................................................... B-1
Frontplane Interrupts ....................................................................................... B-1
Backplane Interrupts ........................................................................................ B-2
Setting Interrupts on the STD-GPIB................................................................ B-2
Appendix C
Customer Communication
................................................................................. C-1
Glossary...................................................................................................................... G-1
Figures
Figure 2-1. Installing the STD-GPIB Board ............................................................ 2-2
Figure 2-2. Completed Installation for the STD-GPIB ........................................... 2-3
Figure 2-3. STD-GPIB Parts Locator Diagram ....................................................... 2-5
Figure 2-4. Base I/O Address Switch Settings ........................................................ 2-8
Figure 2-5. Interrupt Jumper Setting for IRQ11 in a Ziatech Computer ................. 2-10
Figure 2-6. Interrupt Jumper Setting for IRQ5 in a WinSystems Computer........... 2-11
Figure 2-7. Jumper Setting for Disabling Interrupts................................................ 2-12
Figure 2-8. DMA Channel Jumper Setting for DMA Channel 6............................. 2-13
Figure 2-9. DMA Jumper Setting for No DMA Channel ........................................ 2-14
Figure 2-10. Ground Configuration Jumper Settings................................................. 2-15
Figure 2-11. Jumper Settings for 8-Bit and 16-Bit Mode Operation......................... 2-15
Tables
Table 2-1. Hardware Default Settings .................................................................... 2-1
Table 2-2. Possible Base I/O Address Switch Settings .......................................... 2-6
Table 2-3. DMA Channels ..................................................................................... 2-12
Table A-1. Electrical Characteristics....................................................................... A-1
Table A-2. Environmental Characteristics .............................................................. A-1
Table A-3. Physical Characteristics ........................................................................ A-1
Table B-1. J3 Frontplane Interrupt Connector Pinouts ........................................... B-1
Table B-2. STD-GPIB Interrupt Routing................................................................ B-2