Filter
Top Products
BASICA/QuickBASIC GPIB-PC Function Calls Section Four A
GPIB-PC User Manual 4A-10 ©National Instruments Corp.
Table 4A.3 - QuickBASIC GPIB-PC Calls
Description CALL Function Syntax
Change access board of device IBBNA (BD%,BNAME$)
Become Active Controller IBCAC (BD%,V%)
Clear specified device IBCLR (BD%)
Send commands from string IBCMD (BD%,CMD$)
Send commands asynchronously from
string IBCMDA (BD%,CMD$)
Enable/disable DMA IBDMA (BD%,V%)
Change/disable EOS mode IBEOS (BD%,V%)
Enable/disable END message IBEOT (BD%,V%)
Open device and return unit descriptor IBFIND (BDNAME$,BD%)
Go from Active Controller to Standby IBGTS (BD%,V%)
Set/clear ist IBIST (BD%,V%)
Go to local IBLOC (BD%)
Place device online/offline IBONL (BD%,V%)
Change primary address IBPAD (BD%,V%)
Pass control IBPCT (BD%)
Parallel poll configure IBPPC (BD%,V%)
Read data to string IBRD (BD%,RD$)
Read data asynchronously to string IBRDA (BD%,RD$)
Read data to file IBRDF (BD%,FLNAME$)
Read data to integer array IBRDI
(BD%,IARR%(),CNT%)
Read data asynch to integer array IBRDIA
(BD%,IARR%(),CNT%
Conduct a parallel poll IBRPP (BD%,PPR%)
Request/release system control IBRSC (BD%,V%)
Return serial poll byte IBRSP (BD%,SPR%)
Request service IBRSV (BD%,V%)
Change secondary address IBSAD (BD%,V%)
Send interface clear IBSIC (BD%)
Set/clear remote enable line IBSRE (BD%,V%)
Abort asynchronous operation IBSTOP (BD%)
(continues)