© National Instruments Corporation 3 SCC-AI Series Isolated Analog Input Modules User Guide
What You Need to Get Started
To set up and use the SCC-AI, you need the following items:
❑ Hardware
– SCC-68
or
– SC-2345/2350 with one of the following:
• SCC-PWR01
• SCC-PWR02 and the PS01 power supply
• SCC-PWR03 (requires a 7 to 42 VDC power supply,
not included)
– One or more SCC-AI
– 68-pin E/M Series DAQ device
– 68-pin cable
– Quick Reference Label
❑ Software
– The latest version of NI-DAQmx
❑ Documentation
– SCC-AI Series Isolated Analog Input Modules User Guide
– SC-2345/2350 User Manual
– SCC-68 User Guide
or
– SCC Quick Start Guide
– Read Me First: Safety and Radio-Frequency Interference
– Documentation for your hardware
– Documentation for your software
❑ Tools
– 1/8 in. flathead screwdriver
– Numbers 1 and 2 Phillips screwdrivers
– Wire insulation stripper
Note Software scaling of measurements is not supported on the Macintosh operating
system. Refer to the SCC-AI Module Pin Assignments section.