Filter
Top Products
22 InstantWave High Rate 11Mbps Access Point
Figure 16. Hardware Diagnosis
Click Start and the tests will commence. As each item is tested, a yellow arrow
will appear alongside it. If the test is successful, the arrow will change to a green
tick. If a failure occurs, an “X” will appear. You can click Cancel at any time to
stop the tests. When the tests have completed, the Cancel button changes to a
Close button. Click Close to return to the Service card.
Upgrade AP Firmware
From time to time updated firmware is released and may be downloaded from our
website at http://www.ndc.com.tw/support/support.htm
The updated firmware may be installed via a COM port using the AP COMFig tool.
Click on Upgrade AP Firmware (Figure 9, page 12). The Upgrade AP Firmware
dialog box will open (Figure 17).