Filter
Top Products
Quick Start
Figure A.1
3
To attach the AccuSync
™
monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the one end of the 15-pin mini D-SUB of the video signal
cable to the rear of the monitor and the other end to the connector of the
display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the Macintosh cable adapter (not included) to the
monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini
D-SUB end of the video signal cable to the Macintosh cable adapter on
the computer and the other end to the back of the monitor (Figure B.1).
Tighten all screws.
NOTE: To obtain the AccuSync 120 Macintosh cable adapter, call
NEC-Mitsubishi Electronics Display of America, Inc. at (800) 820-1230.
4. Connect one end of the power cord to the AccuSync monitor and the other
end to the power outlet (Figure C.1).
5. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
15-pin mini D-SUB
Video Signal Cable
AS120Manual.wpc 9/13/01, 3:08 PM5