Filter
Top Products
Captive Signal Cable
15-pin mini D-SUB
3
Quick Start
To attach the MultiSync
®
E Series monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1 for MultiSync E750
™
and Figure A.2 for MultiSync E950
™
). Tighten all screws.
For the Mac: Connect the MultiSync E750 or MultiSync E950 Macintosh cable
adapter (not included) to the monitor connector on the Macintosh (Figure B.1).
Attach the 15-pin mini D-SUB end of the captive signal cable to the Macintosh
cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync E750 or MultiSync E950 Macintosh cable
adapter, call NEC Technologies at (800) 820-1230.
4. For download information
on the Windows
®
95/98
INF file for your MultiSync
monitor, refer to the
References section of this
User’s Manual.
5. Connect one end of the
power cord to the
MultiSync E Series monitor
and the other end to the
power outlet (Figure C.1 for
MultiSync E750 and Figure
C.2 for MultiSync E950).
6. Turn on the monitor (Figure
D.1) and the computer.
NOTE: If you have any
problems, please refer
to the Troubleshooting
section of this User’s
Manual.
Figure A.1
15-pin mini D-SUB
Captive Signal Cable
Figure A.2
MultiSync E950
MultiSync E750
78134381.wpc 11/25/98, 2:39 PM5