Filter
Top Products
Quick Start
3
To attach the MultiSync
®
FP955
™
monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync FP955 Macintosh cable adapter (not
included) to the monitor connector on the Macintosh. Attach the 15-pin mini
D-SUB end of the signal cable to the MultiSync FP955Macintosh cable
adapter on the computer. Tighten all screws.
NOTE: To obtain the MultiSync FP955 Macintosh cable adapter, call
NEC-Mitsubishi Electronics Display of America, Inc. at (800) 820-1230.
4. For download information on the Windows
®
95/98/2000 INF file for your
MultiSync monitor, refer to the References section of this User’s Manual.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
Figure A.1
FP955.wpc 1/23/01, 12:13 PM5