NEC LCD1280 Computer Monitor User Manual


 
FCC Information
The Federal Communications Commission Radio Frequency
Interference Statement includes the following warning:
Note: This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment gener-
ates, uses, and can radiate radio frequency energy, and, if not
installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
DOC Compliance Notice
This digital apparatus does not exceed the Class A limits for
radio noise emissions from digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of
Communications.
DOC Avis de Conformation
Le presént appareil numérique n’émet pas de bruits radio-
électriques dépassant les limites applicables aux appareils
numériques de la Class A prescrites dans le Réglement sur le
brouillage radioélectrique édicté par le ministére des
Communications du Canada.
Introduction 1
Contents of Package 1
Introduction to the NEC LCD1280
True Color Monitor 1
Analog Interface 1
Reduced Footprint 1
Low Power Consumption 2
ErgoDesign™ 2
Reduced Emissions 2
LCD1280 Specifications 3
Installation 5
Recommended Use 5
Connection to Graphics Cards
using BNC cables 5
Controls 7
Front Controls 7
Side Control 7
Rear Controls 7
Troubleshooting/Support 9
Troubleshooting Chart 9
Technical Support 10
BBS 10
FastFacts™ 10
Warranty 10
Appendix 1 13
Pin Assignment Table 13
Appendix 2 14
Signal Timings 14
Appendix 3 17
Signal Levels 17
References 18
Index 18
Information for LCD1280
Contents
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol warns user that uninsulated voltage within the unit may
have sufficient magnitude to cause electric shock. Therefore, it is
dangerous to make any kind of contact with any part inside this unit.
This symbol alerts the user that important literature concerning the
operation and maintenance of this unit has been included.
Therefore, it should be read carefully in order to avoid any problems.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE. ALSO, DO NOT USE THIS UNIT’S POLARIZED PLUG WITH AN
EXTENSION CORD RECEPTACLE OR OTHER OUTLETS, UNLESS THE PRONGS CAN
BE FULLY INSERTED.
REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE
COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
LCD1280, ErgoDesign, IPM, Reduced Magnetic Field, and FastFacts are trademarks of NEC Technologies, Inc. NEC is a registered trademark of NEC Corporation.
Copyright ©1995 by NEC Technologies, Inc. All other brand or product names are trademarks or registered trademarks of their respective holders.
LCD1280 10/29/99 9:25 AM Page 2