Filter
Top Products
Quick Start
To attach the MultiSync FE700 monitor to your system,
follow these instructions:
1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card. For more information, refer to the
display card manual.
3. For the PC: Connect the
15-pin mini D-SUB of the
captive signal cable to the
connector of the display
card in your system (Figure
A.1). Tighten all screws.
For the Mac: Connect the
Macintosh Cable Adapter
(not included) to the
monitor connector on the
Macintosh (Figure B.1).
Attach the 15-pin mini
D-SUB end of the captive
signal cable to the
Macintosh cable adapter
on the computer (Figure
B.1). Tighten all screws.
Captive Signal Cable
15-pin mini D-SUB
Figure A.1
Captive Signal Cable
15-pin
mini D-SUB
Mac Adapter
(not included)
Computer
Figure B.1
E-2
0
5
25
75
95
100