NEC NP510WS Projector User Manual


  Open as PDF
of 114
 
28
3. Projecting an Image (Basic Operation)
Note on Startup screen (Menu Language Select screen)
Whenyourstturnontheprojector,youwillgettheStartupmenu.Thismenugivesyoutheopportunitytoselectone
of the 21 menu languages.
Toselectamenulanguage,followthesesteps:
1. Use the , , or button to select one of the 21
languages from the menu.
2. Press the ENTER button to execute the selection.
After this has been done, you can proceed to the menu
operation.
Ifyouwant,youcanselectthemenulanguagelater.
(→[LANGUAGE]onpage58 and 70)
NOTE:Immediatelyafterturningontheprojector,screenickermayoccur.Thisisnormal.Wait3to5minutesuntilthelamplight-
ingisstabilized.
NOTE: If you turn on the projector immediately after the lamp is turned off, the fans run without displaying an image for some time
and then the projector will display the image.
CAUTION:
Theprojectorcannotbeturnedofffor60secondsafterthelampisturnedonandwhilethePOWERindicatorisblinking
green.Doingsocouldcauseprematurelampfailure.
Whenthe[ECOMODE]issetto[ON],theLAMPindicatorwilllightgreen.
Ifoneofthefollowingthingshappens,theprojectorwillnotturnon.
• Iftheinternaltemperatureoftheprojectoristoohigh,theprojectordetectsabnormalhightemperature.Inthis
conditiontheprojectorwillnotturnontoprotecttheinternalsystem.Ifthishappens,waitfortheprojector’sinternal
componentstocooldown.
• Whenthelampreachesitsendofusablelife,theprojectorwillnotturnon.Ifthishappens,replacethelamp.
• Ifthelampfailstolight,andiftheSTATUSindicatorashesonandoffinacycleofsixtimes,waitafullminuteand
thenturnonthepower.
NOTE:TurningtheMainPowerSwitchOffthenBackOn
Allowaminimumof1secondbetweenturningoffthemainpowerswitchandturningitbackonagain.
Thesamewillbeappliedwhenapowerstripequippedwithaswitchandabreakerisused.
Failingtodosocouldresultinnopowertotheprojector.(Therewillbenostand-byLED)
Should this happen, unplug the power cable and plug it in again. Turn on the main power switch.
ENTER
EXIT
MENU
UP
MAGNIFY PA GE
OFF
POWER
ON
AV-MUTE
DOWN
ENTER
EXIT
MENU
UP
MAGNIFY PA GE
OFF
POWER
ON
AV-MUTE
DOWN
MENU
EXIT
ENTER
MENU
EXIT
ENTER
 previous next