NEC NP510WSG Projector User Manual


  Open as PDF
of 114
 
29
3. Projecting an Image (Basic Operation)
VOLUME
L-CLICK
MOUSE
R-CLICK
AUTO ADJ.
ASPECT HELP
FREEZEPICTURE
S-VIDEO
VIDEO
COMPUTER
2
ECO MODE
1
MENU
EXIT
ENTER
STATUS
LAMP
AUTO ADJ. SOURCE
Selecting a Source
Selecting the computer or video source
NOTE:Turnonthecomputerorvideosourceequipmentconnectedtotheprojector.
SelectingfromSourceList
PressandquicklyreleasetheSOURCEbuttonontheprojectorcabinetto
displaytheSourcelist.EachtimetheSOURCEbuttonispressed,theinput
sourcewillchangeasfollows:“COMPUTER1”,“COMPUTER2(DIGITAL/
ANALOG)”,“COMPUTER2”(ontheNP405andNP305only),“VIDEO”,
“S-VIDEO”.Todisplaytheselectedsource,allow1secondtoelapse.
DetectingtheSignalAutomatically
PressandholdtheSOURCEbuttonforaminimumof2seconds,the
projectorwillsearchforthenextavailableinputsource.Eachtimeyou
pressandholdtheSOURCEbuttonforaminimumof2seconds,the
inputsourcewillchangeasfollows:
COMPUTER1→COMPUTER2(DIGITAL)→COMPUTER2(ANALOG)
→VIDEO→S-VIDEO→COMPUTER1→ ...
TIP: If no input signal is present, the input will be skipped.
UsingtheRemoteControl
PressanyoneoftheCOMPUTER1/2,VIDEO,andS-VIDEObuttons.
TIP:TheCOMPUTER2buttonontheremotecontroltogglestheComputer2
sourcebetween[COMPUTER2(DIGITAL)]and[COMPUTER2(ANALOG)](except
ontheNP405andNP305).
SelectingDefaultSource
Youcansetasourceasthedefaultsourcesothatitwillbedisplayed
each time the projector is turned on.
1. Press the MENU button.
The menu will be displayed.
2. Press the button twice to select [SETUP] and press the but-
ton or the ENTER button to select [GENERAL].
3.
Press the
button three times to select [OPTIONS(2)].
4. Press the button six times to select [DEFAULT SOURCE SE-
LECT] and press the ENTER button.
The [DEFAULT SOURCE SELECT] screen will be displayed.
(→ page 77)
5. Select a source as the default source, and press the ENTER but-
ton.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
The source you selected in step 5 will be projected.
TIP: When the projector is in Standby mode, applying a computer signal from a
computerconnectedtotheCOMPUTER1INinputwillpowerontheprojector
andsimultaneouslyprojectthecomputer’simage.
([AUTOPOWERON(COMP1)]→ page 77)
[NP405/NP305]
[NP405/NP305]
[NP610/NP510/NP410/NP310/NP510W/
NP410W/NP610S/NP510WS]
[NP610/NP510/NP410/NP310/NP510W/
NP410W/NP610S/NP510WS]
 previous next